Hendi 230268, User Manual

Page: 11 / 232

11
EN
Should you wish to decrease the amount (-), press
Button SW2.
After defining the value, press Button SW5 once in
order to register the value in the memory.
In the matrix that is presented below you can find
a short description of the functions that can be ad- justed by the user, as well as their default values.
In order to exit the User’s Menu, press hold Button
SW6 for 3 sec. The beeper sounds three times and
message “off” appears on the screen. After closing
the User’s Menu, the machine is shut down.
No Parameter Range Default Indication
1 TEMPERATURE MODE C/F C C
2 BOILER TEMPERATURE 30-92°C 85°C bt
3 TANK TEMPERATURE 30-70°C 60°C tt
4 DETERGENT TIME AT FILLING 100 - 300 s 180 s dF
5 DETERGENT TIME AT CYCLE 0 - 30 s 13 s dc
6 RINSE AID TIME AT FILLING 0 - 90 s 35 s rF
7 RINSE AID TIME AT CYCLE 0 - 30 s 12 s re
8 COLD RINSE 0 (NO) – 1(YES) 1 Cr
9 DRAINING DURATION 20 -60 s 25 s Cd
Maintenance and Repair
After 50.000 washing cycles, a Service reminding
message will be displayed in the screen. Regular
maintenance, performed by licensed technician using original spare parts is essential for proper
function of the machine.
Alarm Indications
If the system records any malfunction, then a
warning message will be displayed on the screen.
If such a condition occurs, please advise the fol- lowing table which describes the problem shortly.
Should you need further assistance, don’t hesitate
to contact your local re¬seller.
ALARM PROBLEM DESCRIPTION
Alarm 1 Water filling time excession
Alarm 2 The water level during draining is not reduced
Alarm 3 Excess time of boiler heating
Alarm 4 Excess time of tank heating
Alarm 5 Water temperature in the boiler is above limits
Alarm 6 Water temperature in the wash tank is above limits
Alarm 7 Cold rinse alarm
Alarm 8 Bath thermometer not connected
Alarm 9 The bath tub thermometer is defective
Alarm 10 Boiler thermometer not connected
Alarm 11 The boiler thermometer is damaged
Alarm 12
The washing cycle was completed but the boiler did not heat up properly (the heating time in the
Thermo-protector function was exceeded).