Ansa RS1 roller door remote control system
Contents
1
General description
2
Fitting the RS 1 control unit. .
3
Operation
3.2
Function of the red LED indicator.
4
RS1 Control board- overview.
5
Electrical connections.
6
Commissioning.
7
Fitting photoelectric safety sensor[s]
7.1
How to align the photoelectric beam[s]
7.2
Photoelectric sensor operation and testing
8
Adding transmitters.
9
Deleting transmitters
10
Dip switch Settings
11
Multi- door control
12
Photoelectric Cell Override
13
Fault diagnostic system.
14
Control inhibit feature.
15
Fitting the optional aerial.
16
Maintenance.
17
Problem solving guide
18
Technical specifications
1
- General Description
2
- Fitting the RS1 Control Unit
Built-in Light
Multi-function Red LED indicator
Operating button
Lugs
Cover
Spare main
board fuses
Trim
Cover screws
Base
The Ansa RS 1control unit is designed to operate roller garage doors fitted with single phase tubular motor drives. Equipped with “rolling code”
high security remote controls, allowing easy memorisation of up to fifteen transmitters.The unit has all the features needed for efficient, safe and
reliable operation of roller doors including built-on courtesy lamp, operating button and multi- function red indicator LED.
Installation instructions
Please read these instructions carefully prior to commencing installation of the unit. Operate unit only when the door is in full view
and free from any obstruction. No one should enter or leave the garage while the door is in motion.
2.1 The electric drive motor, RS1 control and photoelectric safety
sensor are normally fitted to the same side of the door opening.
Select a suitable position for the control unit, within sight of the door,
well away from moving parts, ensuring that :-
a. It can be plugged into an adjacent 13A switched socket.
b. It is within the constraints of the motor lead, using a 'tidy' cable run.
c. It is mounted with the built on lamp at the top.
d. It is fitted at a height of at least 1.6 metres out of the reach of children.
e. It is fitted inside a dry room only ( I.P.44 rating )
2.2 Fitting the enclosure - Refer to figure 1
Remove the courtesy lamp lens from the base by squeezing the sides
of the lens, disengaging the clip in the top of the lens. Remove any
packaging from the lamp. Pull off the trim, and undo the two fixing
screws approximately 8mm, noting that it is not necessary to
completely remove the screws which remain attached to the cover.
Carefully remove the cover by pulling away from the base with a slight
downward movement. The packing box provides a useful fixing
position guide, Fix the base to the wall using the fixing screws and
plugs provided.
Note: Do not allow dust to enter the unit which could
damage the electronics.
Figure 1