AtlasLink User Guide
23
PN 875-0352-D Rev A4
Chapter 2: Installing AtlasLink
In order to use SmartLink, configure the correction output format and baud rate desired, the target
accuracy level (in 2D 1-sigma), and click the “Save” button.
The receiver will then begin to show information below the form indicating the current SmartLink
status. It will only begin outputting corrections once the target accuracy level that you specified
has been reached. Note that if you did not specify any correction formats, the “Outputting
Corrections” will say “No” even if the target accuracy has been reached.
All manuals and user guides at all-guides.com
all-guides.com
