AtlasLink User Guide
7
PN 875-0352-D Rev A4
Chapter 2: Installing AtlasLink
Surface Mount
You can surface-mount AtlasLink with four machine screws (no. 8-32).
To surface-mount AtlasLink:
1.
Determine the desired location for AtlasLink (see “Selecting the Proper Antenna
Location” on page 7).
2.
A template of the bottom portion of the AtlasLink surface-mount has been provided to
you within the included AtlasLink accessories. Use the outer four holes per your
installation.
3.
Place the AtlasLink surface mount template on the desired mounting location. (Note:
Center hole aligns with antenna's center for measurements.)
4.
Use a center punch to mark the hole centers.
5.
Drill the mounting holes with a drill bit appropriate for the surface. Suggested imperial
drill bit size is 11/64” (close fit) or 6/32” (free fit). Suggested metric drill bit size is drill
wire gauge size 17 (close fit, ~4.4mm) or 16 (free fit, ~4.5mm).
6.
Use four machine screws (no. 8-32) to attach AtlasLink to the surface mount adapter
before securing the complete unit to the intended area.
7.
Place AtlasLink surface mount over the mounting holes and insert the mounting screws
through the bottom of the mounting surface into AtlasLink surface mount adapter.
Hand tighten only. Damage resulting from over-tightening is not
covered by the warranty.
Top
Bottom
All manuals and user guides at all-guides.com
all-guides.com
