9
Helvar
| Data is subject to change without notice.
Main menu
Use the Control Panel Keypad to access and navigate and to adjust the menu options – see ‘Navigating the menu with
the Control Panel Keypad’ on page 7.
Below is a table listing the main options available from the Control Panel. Full options details are listed in the next
section.
Menu options
Addresses
Set SDIM, DMX and DALI addresses, including base addresses, and SDIM/DMX
mode.
Ballast output
View and refresh ballast status; pair relay and ballast channels; set output mode.
Unit details
View module serial number, firmware version, and various other service-related
information.
Recall scene
Recall DALI scenes.
Save as scene
Save levels as a DALI scene.
Default scenes
Reset DALI scenes to default settings.
Groups
Group and ungroup relay and ballast channels.
Min. fade time
Set minimum fade times for relay and ballast channels.
Power on level
Set DALI power-on levels for relay and ballast channels.
Failure level
Set (or disable) DALI failure levels for relay and ballast channels.
Override level
Set (or disable) override levels for relay and ballast channels.
Minimum level
Set DALI minimum load levels for relay and ballast channels.
Switch-on level
Set switch-on levels for SDIM/DMX channels.
Hysteresis
Activate / De-activate SDIM hysteresis for relay and ballast channels.
LCD contrast
Adjust the LCD contrast level.
LCD timeout
Activate / De-activate the LCD display timeout function.
Factory reset
Reset all settings to factory defaults.
Use password
Apply password lock to settings (except to ‘Unit details’ and ‘Enter password’
items).
Enter password
Remove the password lock (see ‘Use password’)
