Operating Instructions • ATS3080 • 02-2017 • v01 • 102-01002
Operation
13
f
Push the roller block
2
into the central position until it
engages.
f
With the teeth facing up, insert the tie ribbon
1
approx.
10 cm deep.
f
Slide the roller block
2
right up until the red button
3
engages.
;
It must no longer be possible to pull out the tie
ribbon
1
.
;
The LED 9
Roller block
in the display goes out.
6 3 Adjust attractive force
The ATS3080 has an adjusting knob that can be used to
adjust the attractive force.
2
1
3
4
f
Pull the lock pin
2
on the adjusting knob
3
out of the
gearing.
f
With the lock pin
2
removed, use the adjusting knob
3
to set the desired attractive force.
• Turning clockwise will increase the attractive force.
• Turning anti-clockwise will decrease the attractive force.
;
The selected setting is displayed in the white notch
4
on
the marking ring
1
.
f
Allow the lock pin
2
to lock firmly into place.
6 4 Switching on
f
Check the ATS3080 for readiness.
;
The tie ribbon is loaded and the roller block is locked,
à
"Load tie ribbon" on page 12
;
The tie heads are loaded in the correct direction,
à
"Load tie heads" on page 12
;
The green field is visible on the tie head transport.
;
The deflectors are extended.
If the deflectors are not extended, then a reset is
required
à
"Performing a reset" on page 18
f
Switch the power pack 3080 on at the main switch.
;
The
Signal
and
Power
LEDs on the power pack 3080
illuminate in green.
;
The 10
Reset
LED on the ATS3080 illuminates in green,
à
"Display" on page 10
;
The ATS3080 is ready for use.
f
Perform ten sample bindings.
6 5 Bind
f
Guide the bundle in front of the end cap of the
ATS3080.
NOTE
f
The end cap of the ATS3080 must
not
press against the
bundle.
f
Press the triggering lever and start a binding.
;
The jaws surround the bundle and the binding is carried
out.
