Operating Instructions • ATS3080 • 02-2017 • v01 • 102-01002
Transport, disposal and storage
11
4
Transport, disposal and storage
4 1 Transporting the device
f
Use the supplied case for transport.
4 2 Disposal
Disposal of the ATS3080, the power pack 3080 and
individual subassemblies and the disposal of consumables
and auxiliaries are subject in part to statutory regulations.
Detailed information is available on request from the
appropriate authorities (e.g. regional or national water
boards or environmental authorities).
f
Dispose of packaging materials.
Always dispose of packaging materials in accordance with
the currently valid materials-disposal and environmental
protection regulations.
f
Always take materials for disposal to certified collection
points.
f
Contact the manufacturer if there is any uncertainty
regarding disposal.
4 3 Storage
f
ATS3080 and power pack 3080 must be stored in a cool,
dry place.
f
Avoid direct sunlight.
f
ATS3080 and power pack 3080 must be stored in
dustproof packaging.
f
Store electrical components (ATS3080 and power pack
3080) in impact-absorbing packaging and separately
from the accessories.
f
Consult and comply with the appropriate data sheets for
storage of the accessories.
4 4 Return
f
Use the supplied case for returns, as otherwise you will
be invoiced for the costs of a replacement case.
5
Installation
5 1 Installing the accessories
f
Always proceed in accordance with the instructions
supplied with the accessory in question.
5 2 Set limit
Required tool
• Screwdriver 2.5 mm Allen screw
The screwdriver 2.5 mm Allen screw is not included in the
scope of supply.
Set limit
4
1
2
3
The following limits are available,
à
"Geometries of
bundles" on page 14
:
• Limit 50
4
for jaws diameter 30 mm and diameter
50 mm
• Limit 80
3
for jaws diameter 80 mm
f
Loosen the six screws
1
.
f
Slightly raise the rear housing shell and remove the front
housing shell
2
.
f
Turn the front housing shell
2
.
f
Insert the limit suitable for the bundle into the recess of
the front housing shell
2
from the inside.
f
Push the front housing shell
2
under the rear housing
shell and close the housing.
f
Fasten the housing shells using the screws
1
.
