EN
EN
Cooling register AIR1-KR DX
Installation and Operating Instructions
16
The 16x20 mm long screws must be mounted on the side, the 6x16 mm long screws are intended for the bracket
above�
7. Mount the mounting bracket to the cooling register. Connect AIR1 unit to cooling register as follows (see Fig.23).
8. Fasten the pipe bend below the condensate tray. Ensure that the pipe is water-tight (see Fig.24).
9. Cooling can produce condensate. The correct condensate connection to the sewage system must be ensured
before commissioning. A siphon is required for this purpose. The condensate must drip freely into the drain after
NOTE
Fig�22
Fig�23
Fig�24
