HEIL DuraPack 5000 2017, Operation Manual

Page: 117 / 204

Issued September 2017
On-Route Operation Procedures Copyright 2017, Heil Environmental
Printed in U.S.A.
109
DuraPack
®
5000
DRIVING TO PICK-UP LOCATIONS
Whenever you drive the unit to and from a route, along the
route, to the landfill, etc., make sure the unit is set up as
follows:
The tailgate is fully LOWERED and CLOSED. Check
the TAILGATE UP light in the cab. It must be OFF.
The tailgate clamps (turnbuckles) are tight and
secure the tailgate.
If equipped with a winch or reeving mechanism, the
cable hook is secured in the eye on the tailgate.
The left and right hand access doors are both closed
and secured. For each door:
o
The quick release pin is secured in the barrel.
o
The wing screw is securely tightened against the
door.
For a unit with refuse, the blade is up tight against
refuse. For a unit with no refuse, the blade is at the
START POSITION.
The ejector panel is at the front of the body.
If equipped, the PTO is DISENGAGED.
The PUMP ON switch is OFF.
You properly ADJUST and CLEAN the mirrors.
All outside lights turn ON and OFF.
If equipped, the side access door is CLOSED and
LOCKED.
Use of Curb Side Drive
If equipped, drive from the curb-side driver position ONLY
on the collection route. DO NOT use this station during
travel to or from a route, landfill or transfer station.
BEFORE LOADING
Before you start to load refuse, make sure the packing
mechanism is in the correct position.
1. If equipped, the PTO is engaged. The PUMP ON
switch is ON.
NOTICE
The ejector panel should never be used to
“backpack” (operating the ejector extend function with the
tailgate closed against trash in a fully or partially loaded
unit). This can possibly result in damage to the unit
including structural components and cylinder failure. The
resulting damage will NOT be covered by warranty.
CAUTION
Stand clear when the ejector panel is in motion. Keep side
access door closed when ejector panel is in motion.
Failure to obey may result in minor or moderate injury.