11-5
11
Tables, Overviews and Diagrams
TNC 426/TNC 425/TNC 415 B/TNC 407
3D touch probes and digitizing
MP6300
Reserved
Infeed of the stylus when digitizing with a measuring touch probe
MP6310
0.1 to 2.0000 [mm]
(recommended input value: 1mm)
Measure center misalignment of the stylus when calibrating a measuring touch probe
MP6321
Measure center misalignment:
0
Do not measure center misalignment:
1
Assign touch probe axis to machine axis for a measuring touch probe
MP6322.0
Machine X axis parallel to
Touch probe X axis:
0
Touch probe Y axis:
1
Touch probe Z axis:
2
MP6322.1
Machine Y axis parallel to
Touch probe X axis:
0
Touch probe Y axis:
1
Touch probe Z axis:
2
MP6322.2
Machine Z axis parallel to
Touch probe X axis:
0
Touch probe Y axis:
1
Touch probe Z axis:
2
Maximum stylus deflection on measuring touch probes
MP6330
0.1 to 4.0000 [mm]
Feed rate for positioning measuring touch probes at MIN point and approaching contour
MP6350
10 to 3 000 [mm/min]
Probing feed rate for measuring touch probes
MP6360
10 to 3 000 [mm/min]
Rapid traverse for measuring touch probes in the probe cycle
MP6361
10 to 3 000 [mm/min]
Feed rate decrease when the stylus of a measuring touch probe is deflected to the side
The TNC decreases the feed rate according to a preset characteristic curve. The
minimum input value is 10% of the programmed digitizing feed rate.
MP6362
Feed rate decrease not active:
0
Feed rate decrease active:
1
Target window for digitizing contour lines with measuring touch probes
When you are digitizing contour lines the individual contour lines do not end exactly in their starting points. With
machine parameter MP 6390 you can define a square target window within which the end point must lie after
the touch probe has orbited the model. Enter half the side length of the target window for the input value.
MP6390
0.1 to 4.0000 [mm]
Ensure that the touch probe axes are correctly assigned to the machine axes. Wrong assignment could lead
to a stylus break.
