TNC 426/TNC 425/TNC 415 B/TNC 407
4 - 1 4
4
Programming
Fig. 4.6:
Pocket table for the tool changer
Overview: Information in pocket tables
Pocket table for tool changer
The
TOOL_P
table (for tool pocket) is programmed
in a program run operating mode.
The soft key NEW POCKET TABLE (or RESET
POCKET TABLE) is for erasing an existing pocket
table and writing a new one.
Like the tool table, a pocket table can also be read in
and read out directly through the data interface (see
page 4-11).
To select the pocket table:
Select tool table.
Select pocket table.
Set the EDIT soft key to ON.
To edit the pocket table:
Abbreviation Input
Dialog
P
Pocket number of the tool
–
T
Tool number
TOOL NUMBER
F
Fixed tool number. The tool is always returned to the
same pocket.
FIXED POCKET
YES = ENT / NO = NOENT
L
Locked pocket
POCKET LOCKED
YES = ENT / NO = NOENT
S T
Special tool with a large radius requiring several pockets
in the tool magazine. If your special tool takes up pockets
in front of and behind its actual pocket, these additional
pockets need to be locked.
SPECIAL TOOL
PLC
Information on this
tool pocket
that is to be sent to
the PLC
PLC STATUS
