HEIDELBERG PG.010.000B, User Manual, Page: 62 / 116

Service and Maintenance
62 Version 2019
Note: Punch waste may not be disposed of as household waste. Dis-
pose of the punch waste together with any printing plates you no longer
need at your local waste disposal company.
4. Place the punch waste containers back on the guides. Push them to the
back as far as they can go so that the punch waste is sure to fall into the
container.
5. Close the cover on the front of the device.
6. In the Suprasetter user interface, go to "Administration > Maintenance >
Monitoring" and click the box in the "Punch Waste" row in the "Mainte-
nance Completed" column.
The number of punches in the "Next Maintenance" column is reset to its initial
value.
7. Click "Apply" and confirm the query with "Yes".
The maintenance interval for removing the punch waste starts from the begin-
ning.
8. Run a troubleshooting routine to eliminate the error state of the recorder,
see the
section "Troubleshooting", page 47 .
Removing Punch Waste on a Fully Automated Device
with a Cross Conveyor or OLP Table
If your Suprasetter has an optional punch, a message will request you at cer-
tain intervals to remove the punch waste. In such a case, proceed as follows:
Maintenance interval: 2000 punches
1. In the Suprasetter user interface, click the "Punch Waste" button in
"Administration > Maintenance > Maintenance Work".
The cover on the front of the Suprasetter is unlocked.
Note: The "Punch Waste" button is enabled only if no imaging is run-
ning, i.e. the imaging drum must not be moving. The Suprasetter is set
to an error state after you click the "Punch waste" button.
i
i
i
i