HEIDELBERG PG.010.000B, User Manual, Page: 58 / 116

Service and Maintenance
58 Version 2019
• Water, sponge, sponge cloth, lint-free cloth.
1. In the Suprasetter user interface, click the "Cleaning Roller" button in
"Administration > Maintenance > Maintenance Work".
The cover on the front of the device is released and the cleaning roller is raised
so that you can clean it.
Note: The "Cleaning Roller" button is enabled only if no imaging is run-
ning, i.e. the imaging drum must not be moving. The Suprasetter is set
to an error state after you click the "Cleaning Roller" button.
2. Unlock the wheels of the cross conveyor.
3. Push the cross conveyor approx. 70 cm away from the Suprasetter to be
able to reach the cleaning roller.
Note: If you use an OLP table instead of a cross conveyor, you must
first manually swing up the protective cover on the insertion/ejection
table in order to swing up the OLP table. After that, the OLP table top is
swung up and then the protective cover is lowered again.
4. Open the cover on the front of the Suprasetter.
5. Clean the cleaning roller (1) using a sponge or sponge cloth moistened
with water. Turn the cleaning roller while cleaning in order to clean the
whole surface.
Notice
Do not use any abrasive or scratching cleaning agents or
equipment.
i
i
i
i