7
196349 rev 1
EN
6.6 Program mode
This mode is for your everyday use. It helps you run the dry-
er with pre-installed programs and edit program settings.
To enter the program mode, turn
the main switch on
When you start the dryer, an information screen will
appear for two seconds. By pressing the confirmation
or cancellation button this information will show until
released. The diagram shows cassette filter usage and
notifies when it’s time to change filter. To replace filter,
see chapter 10.
6.7 Settings mode
The Settings mode enables you to change advanced sys-
tem parameters. Thanks to our advanced control system
in this dryer, there are many settings that can be altered.
This is normally not a part of the everyday usage.
To enter the settings mode, press both arrow keys when
you turn the main switch to position 1.
Read chapter 9 for more information.
6.8 Program interruption
To stop the heating before the automatic end of the
program (Continues mode off), press the Start/Stop but-
ton. If external Start/Stop, press the external Start/stop
button.
Note!
For the IR lamps to cool down and thereby last
longer, the fans continue to go and turn off automatically
with 3 minutes delay.
6.9 Tempertaure switches
There is a temperature sensor on the circuit board which
you can read in ºC or ºF depending on your settings.
There is a temperature switch on each cassette and if it’s
tripped the display will show the value 500.
6.10 Edit settings during process
To edit power level or temperature press
Edit
and pass-
word, arrow up/down then press
Save
.
Summary of Contents for IRT System Series
Page 19: ...70 196349 rev 1...
