Heatilator NASIM, Manual, Page: 23 / 32

09-02 23 30532 Rev D
NASIM REAR DIRECT VENT DECORATIVE GAS APPLIANCE
J. LIGHTING INSTRUCTIONS
A . This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to close gas line. Never use tools.
If the knob will not push in or turn by hand, don’t try to
repair it; call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which as been
under water.
WARNING!
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
Stop! Read the safety information above on this label!
TO TURN OFF THE GAS TO THE APPLIANCE
1.
Turn off the wall switch or set thermostat to lowest
setting.
2. Open the control access panel.
3. Turn manual shutoff valve to CLOSED position. Do
not force.
4. Close control access panel.
1. Turn off all wall switches to the appliance or set the
thermostat to the lowest setting (if applicable).
2 Open the control access panel.
3 Turn gas line to “CLOSED”. Wait 5 minutes to clear
out any gas. Then smell for gas, including near the
floor. If you smell gas, STOP! Follow “B” in the safety
information above on this label. If you don’t smell gas,
go to the next step.
4 Turn gas line valve to “OPEN”.
5 Turn pilot knob clockwise to “OFF” (knob may have to
be depressed to pass the “PILOT” position).
6 Locate pilot assembly inside appliance.
7 Locate red ignitor button in the bottom of the
appliance.
8 Turn pilot knob to “PILOT” and push in.
9 Continue to hold in pilot knob and push the red ignitor
button 12-15 times until small blue pilot flame
appears.
10. Continue to hold in pilot knob for approximately one
minute. Pilot should remain lit. If pilot goes out, wait
5 minutes and repeat Steps 4-9.
11 Release and turn the knob counterclockwise to “ON”.
Turn the wall switch to “ON” to light the main burner.
Do not light by hand!
12. If the appliance will not operate, follow the instructions
“To Turn Off Gas To Appliance” and call your service
technician or gas supplier.
For your safety read before lighting.
All manuals and user guides at all-guides.com