22
31282 Rev Q
09/04
CALIBER B-VENT INSTALLATION INSTRUCTIONS
WARNING!
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
WARNING!
Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid or similar liquids in this appli-
ance. Keep any flammable liquids a safe distance from the appliance.
3. Operating the Outside Air Kit
The outside air kit is an optional feature for this
appliance. The outside air kit helps to decrease the
amount of room air taken by utilizing outside air for
combustion. It is strongly recommended that it be
installed.
To operate the outside air kit, before starting the
appliance, open the control access panel. Grasp the
small, black handle located on the left side of the
appliance, just below the glass channel. See
Figure 28. Lift the handle out of its slot and pull towards
the front. The outside air door should open. Replace
the handle back in the slot on the bracket from which
it was removed (so the outside air door remains open)
and close the control access panel. When through
burning the appliance, open the control access panel,
grasp the handle and push the outside air door
closed.
Figure 28 - Operating the Outside Air Kit
L. START-UP ISSUES
ISSUE
SOLUTIONS
1.
Condensation on the glass.
1.
This is a result of gas combustion and temperature variations. As
the appliance warms, this condensation should disapear.
2.
Blue flames.
2.
This is a result of normal operation and the flames will begin to
yellow as the appliance is allowed to burn.
3.
Odor from appliance.
3.
When first operated, this appliance may release an odor for the
first several hours. This is caused by the curing of the paint and
the burning off of any oils remaining from manufacturing.
4.
Film on the glass.
4.
This is a normal result of the curing process of the paint and logs.
Glass should be cleaned within 4-6 hours of initial burning to
remove deposits left by oils from the manufacturing process. A
non-abrasive cleaner, such as Brasso may be necessary.
CAUTION:
The air kit handle may get hot while burning the
appliance. Use care when operating the handle.
f i r e - p a r t s . c o m
