20
31282 Rev Q
09/04
CALIBER B-VENT INSTALLATION INSTRUCTIONS
2. Standing Pilot Ignition
FOR YOUR SAFETY
READ BEFORE OPERATING
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A.
This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building
•
Immediately call your gas supplier from a neighbor’s phone. Follow the supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in or turn the knob. Never use tools. If the knob will not move by hand, don’t try to repair it - call
a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any gas control which has been under water.
TO TURN OFF GAS TO APPLIANCE
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label!
1.
Turn off all wall switches to the appliance.
2.
Open control access panel.
3.
Turn gas line to “CLOSED”. Wait 5 minutes to clear out any
gas. Then smell for gas, including near the floor. If you
smell gas, STOP! Follow “B” in the safety information above
on this label. If you don’t smell gas, go to the next step.
4.
Turn gas line to “OPEN”.
5.
Turn pilot knob clockwise to “OFF”. Knob may have to be
depressed to pass the “PILOT” position.
6.
Locate pilot assembly inside the appliance.
7.
Locate red ignitor button.
8.
Turn pilot knob to “PILOT” and push in.
9.
Continue to hold in pilot knob and push the red ignitor
button 12-15 times until small blue pilot flame appears.
10.
Continue to hold in pilot knob for approximately 1 minute.
Pilot should remain lit. If pilot goes out, wait 5 minutes and
repeat Steps 4-9.
11.
To light the main burner, release and turn the knob
counterclockwise to “ON”. If the appliance is connected to
a wall switch, turn it to “ON”. Do not light by hand.
12.
If the appliance will not operate, follow the instructions “To
Turn Off Gas To Appliance” and call your service technician
or gas supplier.
1.
Turn off the wall switch or set thermostat to lowest setting.
2.
Open control access panel.
3.
Turn gas line to “CLOSED” position. Do not force.
4.
Close control access panel.
f i r e - p a r t s . c o m
