20
33795 Rev i
01/04
CALIBER DESIGNER SERIES
4. Venting System Inspection
The appliance and venting system should be inspected before use, and at least annually, by a qualified field service
person, to ensure that the flow of combustion and ventilation air is not obstructed.
5. Cleaning the Glass
See Figure 23. Never operate this appliance without the glass properly secured in place or if the glass is broken.
In the event of glass breakage, carefully remove the glass frame. This will allow the removal of all glass fragments
and sheet metal edge protection strips. Vacuum all remaining glass pieces with a shop vac.
DO NOT VACUUM IF
PIECES ARE HOT!
Replace glass with a Heatilator glass panel assembly only, ordered through your local distributor. Never use
substitute material.
6. Log Removal/Replacement
If removal of the logs becomes necessary, remove
the four screws at each end of the grate. Grasp the
grate as shown. Pull the logs up and off the burner.
See Figure 24.
To replace the logs, grasp the grate as shown. Lower
the log set onto the burner pan, making sure the grate
bars drop into holes provided. Attach the four screws
at the end of the grate.
Figure 23 - Glass Cleaning
Figure 24 - Log Removal
Safety Note:
Handle glass
with care to
avoid striking,
scratching or
s l a m m i n g
shut.
NEVER
clean glass
when hot. Keep
children and
pets a safe
distance away.
