34
Heatilator • Birmingham BIR50-B Installation Manual • 4059-701 • Rev G • 06/29/15
D. Install Screens
• Lay one screen panel flat and slide the round end of
the rod through the rings starting at the handle side of
screen. Leave the last ring off the rod.
• Insert the rod through the hole in the bracket. Slip the
last ring over the rod on the other side of the bracket.
• Fasten the flat end of the screen rod back in place using
the screw removed earlier.
• Repeat for the other screen panel.
Center of Fireplace Opening
Round end of Rod through rings,
then into Screen Rod Clip
Rod Screen
Clip
Inside
Firebox
Top of Fireplace
E. Install Mortar (Optional)
The brick panels have been designed for installation
without the use of mortar being necessary. If the look of
mortar is preferred, it is available and can be installed.
Follow the directions on the container for mixing.
Clean sparingly as paint will rub off and may need to
be touched up. Touch up paint is available as an ac-
cessory.
F. Grate
• Install the grate if a gas log set is not going to be installed.
• Position the rear grate bar in the Grate Retainer.
• Position the top of the grate retainer over the rear grate
bar and fasten in place with screw provided.
Figure 7.3 Install Screens
Note:
Herringbone refractory may require two buckets
of mortar. The Tranditional requires only one.
