-2-
598-1123-02
To mount with screws, remove back of case by
pushing in tab on bottom with a small screwdriver
(see Figure 1).
attach back of case to door jamb or wall. Snap
front of push button on.
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any code settings
on your chime and push button.
WARNING: Turn off power supply at junction box whenever chime is
removed from wall.
The push button and chime communicate by using a code that can be changed
by changing dip switch positions or removing and/or adding jumpers on both the
push button and chime. The code is factory set; however, there are 128 selectable
codes that allow you to expand your system and prevent outside interference.
other wireless products may cause interference and the system may not function
properly. Follow the instructions below for setting a new code.
1. Turn off power supply at junction box.
2. remove chime from wall.
3. open the push button case and locate dip switches/jumpers in push button
and on rear of chime.
4. The push button has eight dip switches/jumpers and the chime has seven
dip switches/jumpers. Dip switch/jumper positions 1 through 7 are used for
setting the code.
5. To change the code, change dip switch positions or add and/or remove
jumpers as needed. It is recommended to only change one code position at
a time and then check to see if system is functioning properly. Note: code
positions 1 through 7 must be exactly the same for both the push button and
chime for this system to function.
Note: Unit will come factory set with dip switch locations 5, 6, and 7 in the “on”
position and/or jumpers in locations 5, 6, and 7 (see Figure 4).
Figure 3
