-3-
598-1123-02
Tune Settings
Your wireless chime has different selectable tunes:
Ding (one note) and Ding-
Dong (two note). The factory setting is for the Ding-Dong tune. This tune can
be changed by following the instructions below.
•
Ding (one note tune)
In Push Button only - Set dip switch 8 to “on” position or add jumper.
•
Ding-Dong (two note tune)
In Push Button only - Set dip switch 8 to “oFF” position or remove jumper.
Note: all Heath
®
/Zenith models have both front and back door tune capabili-
ties. We recommend the back door use the
Ding tune and the front door use
the
Ding-Dong tune. models that include two push buttons will come factory
set for front and back doors. Decals on the rear of the push button will indicate
its setting.
Replacing Push Button Batteries
Install two lithium type CR1220 3 volt
batteries. See diagram inside push button
for correct orientation of batteries.
rear of chime
1
2
3
4
5
6
7
O
N
Figure 4
1
2
3
4
5
6
7
8
O
N
CR
1220
+
Inside Push
Button
* code Settings 1-7
must match Both Push
Button and chime
Tune Setting
(+) Positive
Battery
Terminal
Insert Batteries (+)
Positive Side Up
Note: Some models might require the use of tweezers to
remove and replace the jumpers or a small screwdriver
to set dip switches.
