Heat & Glo • TRUE-36, TRUE-42, TRUE-50 Installation Manual • 2282-980 Rev. F • 8/14
42
B. Finishing Templates
Two side
fi
nishing templates and one top
fi
nishing template
are supplied with the appliance. They are fastened to the
top surround.
INSIDE FIT Method: The
fi
nishing template pieces are
required for installations that require more than one inch
thick
fi
nishing materials to be installed over the face of the
factory-supplied 1/2 inch non-combustible board. Refer
to section 10.D for more information.
OVERLAP Method: The supplied templates are not
required for
fi
nishing materials less than one inch thick.
The required decorative front will overlap
fi
nish materials
less than one inch thick. Refer to section 10.D for more
information.
Arch Decorative Front Application:
If an arch
decorative front option is chosen, an Arch Template
Kit is required to be installed prior to the installation of
the decorative
fi
nishing materials. This kit includes new
fi
nishing templates (3) and arch corner
fi
ll pieces (2).
Contact your dealer to order the correct Arch Template Kit
for your
fi
replace model.
Template Installation Instruction
1. Locate the four threaded inserts on the inside edge of
the
fi
replace and secure the side templates with the
Phillips screws provided. See Figure 10.4.
2. Bend the top template as shown in Figure 10.2 and
secure with the two screws provided. The bend will
have two opposing 90 degree bends, similar to the
bends on the side templates.
3. Remove all template components once
fi
nishing
materials are secured.
Figure 10.3 Left and Right Side Finishing Template Bends
TOP FINISHING
TEMPLATE
SIDE FINISHING
TEMPLATES
Figure 10.4 Top and Side Finishing Template Locations
Note:
For Firesceen Fronts (denoted with “FS”), a thin
layer of mortar may be applied over the visible non-
combustible board between
fi
nishing material and the
fi
replace opening.
Figure 10.2 Top Finishing Template Bend
1-1/4 IN.
TAB
3/4 IN.