64
Heat & Glo • SL-3X-IFT, SL-5X-IFT, SL-7X-IFT, SL-9X-IFT Installation Manual • 2472-980 Rev. Q • 3/20
I. Install Decorative Front
WARNING! Risk of Fire!
Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts could cause fireplace to overheat.
This fireplace has been supplied with an integral barrier
to prevent direct contact with the fixed glass panel. DO
NOT operate the fireplace with the barrier removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative door or front.
G. LED’s
LED’s are factory-installed. No additional set up or
activation required.
Figure 11.9 Fixed Glass Assembly
H. Install Fixed Glass Assembly
WARNING! Risk of Asphyxiation!
Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
•
DO NOT
strike, slam or scratch glass.
•
DO NOT
operate fireplace with glass removed, cracked,
broken or scratched.
•
Replace as a complete assembly.
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
GLASS
ASSEMBLY
LATCHES
(BOTH BOTTOM
AND TOP)
F. IntelliFire Touch
®
Control System Setup
• Detailed instructions for electrical wiring and connec-
tions are provided in Section 8.
• Determine if this appliance is equipped with a Module
Reset Switch. See Section 8. Verify this switch is in
the ON position.
• Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operating
Instructions for the IFT-ECM are provided in Section
3.J of the Owner’s Manual.
Figure 11.6 IFT-ECM
This appliance is factory-equipped with an
IntelliFire
Touch
remote control. The remote was paired to the fire
-
place and tested at the factory. It does not need to be
paired again, unless an accessory kit will be added at
the time of installation. If no additional accessory will be
added, simply follow steps one through seven below.
1. If installed, remove batteries from remote.
2. Verify that the new appliance has power and secure
electrical connections.
3. Adjust the ECM selector switch to ‘REMOTE’ mode.
4. Switch the master reset switch to ‘ON’ (if equipped).
5. Wait to verify LED indicator on the ECM stops flash
-
ing.
6. Install batteries in the RC400 remote.
7. The RC400 remote will automatically pair to the appli
-
ance as pre-set at the factory.
3 POSITION SWITCH
TOP VIEW
LED INDICATOR