HearthStone
Quality Home Heating Products Inc
®
Bennington Model 8350
12
¦
WARNING:
DO NOT CONNECT THE
STOVE TO A CHIMNEY
FLUE SERVING
ANOTHER APPLIANCE.
Make sure the size of the
chimney’s flue is appropriate for
the Bennington. The Bennington
requires a 6" (152 mm) inside
diameter flue for new
installations. A 6” diameter flue
provides adequate draft and
performance. You can use an 8"
(203 mm) diameter existing flue
with a reducer. An oversized
flue contributes to creosote
accumulation. (In this case,
bigger is NOT better.)
When purchasing a prefabricated
chimney to install with your
stove, be sure to also purchase
from the same manufacturer the
wall pass-through (or ceiling
support package), "T" section
package, fire-stops (when
needed), insulation shield, roof
flashing, chimney cap, and any
other needed accessories. Follow
the manufacturer’s instructions
when installing the chimney and
accessories. In addition, be sure
to maintain all manufacturers’
recommendations for the proper
clearances to the chimney.
There are basically two ways to
install a prefabricated metal
chimney:
•
An
interior
installation
where the chimney passes
inside the residence through
the ceiling and roof.
•
An
exterior
installation
where the chimney passes
through the wall behind the stove
then up the outside of the residence.
Whenever possible, choose an interior chimney. An
interior chimney heats up more quickly and retains its
heat; thus promotes a better draft and dis courages the
formation of creosote. An exterior chimney does not
benefit from the warmth of being surrounded by the
building, so it typically operates at lower flue
temperatures than an interior chimney. An exterior
chimney’s draft is not as strong and may experience
increased creosote accumulation.
Chimney is supported by Tee Support Bracket.
Tee Support Bracket
Tee clean-out
Adjustable Roof
Wall Strap
Chase Enclosure
Chimney Sections
Flashing
Storm Collar
Chimnet Cap
Chimney through outer wall with enclosed chase.
Starter section
Collar with built-in
Support Box and Trim
Two story house installation with attic.
Firesafe Enclosure
Firestop Radiation
Adjustable Roof
Chimney Cap
Wall Thimble
Tee
Stovepipe
Attic Insulation Shield
Chimney Sections
Twist-Lock
Support Bracket
Extended Roof
not included)
(Conduit
Flashing
Storm Collar
or other Lined Masonry Chimney
Tee
Chimney pipe through Clay tile
section
Adjustable Roof
Flashing
Storm Collar
Chimnet Cap
Chimney is supported by Ceiling.
Starter
with built-in
Support Box
One story house installation with attic.
Access door
other Liner
Clay tile or
Shield
Wall Thimble
Access door
Stovepipe
Shield
Insullation
Masonry Chimney
Chimney Sections
Tee clean-out
Adjustable Roof
Flashing
Storm Collar
Chimnet Cap
