HearthStone Quality Home Heating Products, Inc ®
23
WFP-75 Model 8411
5.1.6
REPLACING THE DOOR GLASS
The glass used in the WFP-75 is 5 mm thick of dimension 13.65" x 25.3" (34,5 cm x 64,3 cm) and tested to
reach temperatures up to 1400º F. If the glass breaks, it must be replaced with one having the same
specification. Contact your HearthStone dealer to obtain a genuine replacement part (see “replacement
parts”, in appendix to get the proper part number).
WARNING
•
TEMPERED GLASS OR ORDINARY GLASS WILL NOT WITHSTAND THE HIGH
TEMPERATURES OF THE WFP-75.
•
DO NOT ABUSE THE GLASS DOOR BY SLAMMING IT AGAINST THR FIREPLACE.
•
DO NOT OPERATE THE FIREPLACE WITH A CRACKED OR BROKEN GLASS.
In order to replace the glass, use the following procedure:
1. Remove the door (Refer to Appendix 2)
2. Remove the 8 glass clips
(B)
and pads
(C)
held in place with 8 screws
(A)
3. Remove the glass
(D)
4. Remove the glass gasket
(E)
5. To install the new glass, follow the above steps in reverse order, using the adhesive included in the
glass kit to fix the new glass gasket in place.
5.1.7
CLEANING AND PAINTING THE FIREPLACE
Do not attempt to clean or paint the fireplace when the unit is hot.
Painted surfaces can be wiped
down with a damp cloth. Plated surfaces may be scratched by abrasive cleaners. To maintain the finish at
its original brilliance, use only a damp soft cloth to clean plated surfaces.
If the paint becomes scratched or damaged, you can give your wood fireplace a brand new look by
repainting it with heat-resistant paint. Before painting, roughen the surface with fine sand paper, wipe it
down to remove dust, and apply two thin coats of paint. For best results, use the same paint that was
originally used on the fireplace, which is available in spray cans. See your dealer for details.
