This digital apparatus does not exceed the limits (Class A, Class B) for radio noise emissions from
a digital apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
This device complies with RSS-210 of Industry and Science Canada. Operation is subject to the
following two conditions:
1)
This device may not cause noise interference.
2)
This device must accept any interference, including interference that may cause undesired
operation of the device.
All wiring should be done by a qualified electrician and shall be in compliance with local codes
and with the National Electric Code ANSI / NFPA No 70- current (in the United States) or with
current CSA C22.1 Canadian Electric Code (in Canada).
Installation Instructions
Fireplace Installation:
1)
Secure the fireplace mounting plate to the floor of the fireplace by using the adhesive on
bottom of mounting plate or 2 self-drilling screws provided as shown in Figure 1.
2)
Slide the Remote Receiver into the fireplace mounting plate as shown in Figure 1.
3)
Slide the battery compartment into the Remote Receiver as shown in Figure 2.
4)
Place the switch cap on the slide switch.
5)
Feed both wires from the Remote Receiver through hole in the backside of Heat Shield. Place
Heat Shield over Remote Receiver leaving front exposed. Heat Shield will prevent Remote
Receiver from overheating.
6)
See “Wiring the Remote Receiver” to complete wiring.
Figure 1
Figure 2
Wall Mount Installation:
1)
Secure the Remote Receiver to the wall receptacle as shown in Figure 3.
2)
Secure faceplate to the Remote Receiver using 2 screws provided as shown in Figure 3.
3)
See “Wiring the Remote Receiver” to complete wiring.
Figure 3
11/14/06
186
Page 2 of 5
Wiring the Remote Receiver:
