6
2
75
75
1
72
45
1. Attach the Front Stabilizer (2) to the front of the
Frame (1) with two M10 x 75mm Carriage Bolts (72)
and two M10 Nylon Locknuts (45). Make sure that
the Front Stabilizer is turned so the Wheels (75) are
not touching the floor.
2. Attach the Rear Stabilizer (3) to the rear of the
Frame (1) with two M10 x 82mm Carriage Bolts (63)
and two M10 Nylon Locknuts (45).
3. While a second person holds the Upright (6) near
the Frame (1) as shown, connect the Upper Wire
Harness (16) to the Lower Wire Harness (77).
Carefully slide the Upright (6) onto the Frame (1); be
careful to avoid pinching the Wire Harnesses
(16, 77). Slide the Upright to the desired height and
then attach it with four M8 x 25mm Button Screws
(27) and four M8 Split Washers (70). Note: The
height of the Upright can be adjusted later if desired.
2
3
63
3
6
27
27
70
70
1
16
77
4. The Console (9) requires four “D” batteries (not
included); alkaline batteries are recommended.
Remove the battery cover from the back of the
Console. Press four batteries into the Console as
shown. Make sure that the negative (–) ends of
the batteries are facing the springs. Reattach the
battery cover.
Refer to inset drawing A. Connect the wire harness
on the Handgrip Pulse Sensor (71) to the indicated
wire harness on the Console (9). Insert both wire
harnesses into the opening in the bottom of the
Console. Next, insert the metal tube on the Handgrip
Pulse Sensor into the opening in the bottom of the
Console. Be careful not to pinch the wire har-
nesses.
Refer to inset drawing B. Align the holes in the
bracket on the Console (9) with the holes in the
metal tube on the Handgrip Pulse Sensor (71).
Tighten two M4 x 12mm Screws (60) through the
bracket into the tube as shown.
Wire Harnesses
45
45
1
Batteries
Battery
Cover
Bracket
Tube
Tube
1
4
A
B
9
60
60
9
71
71
9
