7
6. Identify the Left Handlebar (9), which is marked with a
“Left” sticker. Insert the Left Handlebar into one of the
Handlebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Leg with two M8 x 45mm Button Bolts (50)
and two M8 Nylon Locknuts (46). Make sure that the
Nylon Locknuts are inside the hexagonal holes. Do
not tighten the Button Bolts yet.
Repeat this step for the Right Handlebar (not
shown) and the other Handlebar Leg.
6
9
50
46
Hexagonal
Holes
79
Grease
Tube
Arrow
7
38
25
9
2
23
22
53
95
5. While another person holds the Console (5) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (86). Insert the
excess wire harness into the Upright (2). Next, attach
the Console to the Upright with four M4 x 16mm
Screws (66). Be careful to avoid pinching the wire
harnesses.
5
86
66
66
2
Wire
Harness
5
Avoid pinching
or damaging the
wire harnesses
during this step.
7. Apply a generous amount of the included grease to the
Pivot Axle (38) and to an M8.5 Washer (53). Next, insert
the Pivot Axle into the Upright (2) and center it. Reapply
grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (25) onto the short tube on
the Left Handlebar (9), and rotate the Handlebar Spacer
so the small arrow is pointing downward. Next, slide the
Left Handlebar onto the left end of the Pivot Axle (38).
Hand tighten an M8 x 25mm Patch Screw (22) with an
M8.5 Washer (53) and a Wave Washer (95) into the end
of the Pivot Axle. Then, press the small tabs on a
Handlebar Cap (23) into the Handlebar Spacer.
Assemble the Right Handlebar (not shown) and the
other Handlebar Leg in the same way.
Tighten both M8 x 25mm Patch Screws (22) at the same
time.
Summary of Contents for C515e Elliptical
Page 16: ...16 NOTES ...
Page 17: ...17 NOTES ...
