Healthrider C515e Elliptical, User Manual

Page: 6 / 20

6
1.
Identify the Front Stabilizer (3). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 112mm
Carriage Bolts (34) and two M10 Nylon Locknuts (29).
Make sure that the Front Stabilizer is turned so the
Wheels (32) are not touching the floor.
3
29
32
32
34
1
1
2. While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (4) to the Frame with two
M10 x 112mm Carriage Bolts (34) and two M10 Nylon
Locknuts (29).
34
4
1
3
2
86
93
91
87
1
63
83
83
70
70
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (86) to
the Lower Wire Harness (87). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack. While holding the upper end of the
Upper Wire Harness, insert the Upright into the
Frame (1). Do not pinch the Wire Harnesses.
Slide two M10 Split Washers (70) and two Frame
Spacers (83) onto two M10 x 88mm Button
Screws (63). Insert the Button Screws into the Frame
(1) and the Upright (2). Make sure that the concave
end of the Frame Spacer is turned toward the
Frame. Do not tighten the Button Screws yet.
Attach the Water Bottle Holder (91) to the
Upright (2) with two M4 x 22mm Screws (93).
2
29
29
Avoid pinching
or damaging the
wire harnesses
during this step.
4. The Console (5) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. Remove the
battery cover from the Console and insert four batter-
ies into the Console. Make sure that the batteries
are oriented as shown by the markings on the bat-
tery cover. Then, reattach the battery cover.
Battery
Cover
5
Batteries
Batteries
4
To make assembly easier, read the information
on page 5 before you begin assembling the
elliptical exerciser.
29