Operating Instructions
Point to multicast network configuration:
1. Connect one HDMI Cable between the HDMI output port of source device and the HDMI input port of
Transmitter unit
1.
. Connect one CAT5e or better cable between the RJ45 port of transmitter and input port of Gigabit Ethernet
switch hub.
3. Connect one CAT5e or better cable between the output port of each Gigabit Ethernet switch hub and RJ45
port of Receiver unit.
5. Power on the output device first and then the source device.
6. If DIP switch at the transmitter is set up: Group ID:0001, then DIP switch at each receiver should be set up
as same as the transmitter: Group ID:0001
Modify the TX and all RX for a different IP & MAC address in LAN (local area network
）
to avoid conflict.
6
