HBM QuantumX MX1609, Operating Manual, Page: 15 / 181

15 Introduction
HBM QuantumX
S
MX1615 bridge amplifier
The module has 16 individually configurable inputs for strain gauges in quarter-, half- and
full-bridge configuration. DC or carrier-frequency (600 Hz) bridge excitation.
S
Data recorder CX22 / CX22 − W (WLAN)
The module is used for local recording of measured data.
The modules have the following in common:
S
Low voltage connection
S
Ethernet interface for data communication with an operating PC
S
2 FireWire interfaces
−
For optional voltage supply (see data sheet)
− For optional data communication via PC
− For medule synchronization
− For internal transmission of measurement data
S
Connector (VG strip) for installation on an active module carrier (not applicable for P
variants)
S
Status LEDs for displaying general system and channel states
S
A working standard calibration certificate has been stored on every amplifier. It can be
read out via QuantumX Assistant.
S
AutoBoot (module configuration is retained)
With amplifiers, the following applies for each measurement channel:
S
Electrical isolation (signal inputs/outputs, voltage supply, communication) for active
sensors
S
Configurable supply voltage for active sensors
S
Support for TEDS
*)
technology (read, write)
S
Configurable sampling rate
S
Configurable active digital filter (Bessel, Butterworth)
S
Configurable Scaling (can also be saved to the TEDS)
Sensors assigned via the sensor database can be measured (calibrated) via the channel and
rewritten to the sensor database.
*)
TEDS = Transducer Electronic Data Sheet