
Structure and mode of operation
PW15iA
A4359-1.0
HBM: public
19
Notice
The transducers are precision measuring elements, and
need to be handled carefully. Dropping or knocking the
transducer may cause permanent damage. Make sure
that the transducer cannot be overloaded, including while
it is being mounted.
5.2
Mounting and load application
Before installing
several
digital load cells into an installa
tion with a bus system, take the following into account:
S
The printed production number (type plate) is required
for setting up data communication. If the type plate
can no longer be seen after installation, the numbers
of each transducer should be noted beforehand. This
enables different addresses to be assigned during
initial operation.
S
Alternatively,
before
connection to the bus system,
you can connect each transducer individually with a
PC, in order to set different addresses (see
ADR
command in online help).
Mount the transducer on a clean surface with a flatness
better than 0.1 mm. You can integrate overload protec
tion with an M6x0.5 fine-thread screw.
To minimize off-center load errors and torques, load
should be applied in the center of the platform.
Summary of Contents for PW15iA
Page 1: ...Mounting Instructions Montageanleitung Notice de montage English Deutsch Fran ais PW15iA...
Page 102: ...limination des d chets et protection de l environnement 36 A4359 1 0 HBM public PW15iA...
Page 103: ...limination des d chets et protection de l environnement PW15iA A4359 1 0 HBM public 37...