HB-100/140/160Z1
Temperature Control Unit
Maintenance
110
O8285-EN 2017-12
Run software update
Fig. 77: Connect USB data carrier
Fig. 78: Start USB software update
1.
Switch on main switch.
2.
Connect USB data carrier (Fig. 77).
3.
Display menu page
Profile
.
4.
Set parameter
User profile
to "Enhanced".
5.
Display menu page
Save/Load
.
6.
Select function
Start USB Software Update
and confirm with
the
key.
The data is loaded from the USB data carrier to the memory in
the USR-51. Do not disconnect the USB connection.
Conclusion of data transfer is indicated on the display. The
USB connection can now be disconnected.
The new software is written to the USR-51 flash. On
completion, an automatic restart is initiated.
7.
If required, the USB connection must be re-established to
install further data.
If necessary, the new software is written to the connected
GIF-51, DFM-51 or VFC-51 after the restart. This process can
take a few minutes. On completion, another restart takes
place.
The message
Ready to operate
appears on the display.
Checking the software version
1.
In the basic display, press the
key.
The current software version appears at the top right.
