HB-THERM M8146-EN, Assembly Instructions Manual

Page: 6 / 16

Assembly Instructions M8146-EN
M8146-EN 2019-07
6/16
on the multiphase motor, the buffer module (M 7)
Fig. 7: Disassemble the multiphase
motor M 7
5. Proceed as follows to disassemble the multiphase
motor (M 7):

Withdraw the cable connector of the multiphase motor (M 7).

Loosen 2x fixing screws (label 1) of the multiphase
motor (M 7).

Turn the multiphase motor (M 7), slightly pull out downwards
and move out of connection.
Fig. 8: Replacing the guide bush
6. Proceed as follows in order to replace the guide bush:

Remove the fixing screw (label 5) holding the guide bush at the
bottom of the switching (20) resp. buffer module (21).

Remove the guide bush (label 6).
NOTICE!
Do not remove the mounting rod to assemble the
guide bush.

Assemble the new guide bush. The mounting rod is being
pressed out by the piston.

Remove the mounting rod, it is no longer needed.

Fix the guide bush with the fixing screw.
7. Proceed as follows to mount the multiphase motor (M 7):

Engage the multiphase motor, turn into final position and fix
with the two screws.

Connect cable plug of the multiphase motor.
8. Carry out inspection (

page 16).
1
6
5