Haybuster 2100 BALEBUSTER, Operating Instructions And Parts Manual, Page: 34 / 90

26
2 1 0 0 B A L E B U S T E R O P E R A T I N G I N S T R U C T I O N S
3.4 Adjusting the machine
3.4.1 Changing distribution pattern
The deflector can be positioned for creating a windrow, spreading, bunkfeeding, or stockpiling. Lower the deflector for
a narrower windrow and raise the deflector for a wider spread.
To change the position, pull the release lever, Rotate the deflector to the desired position and release the handle. A
wider deflector belt (PN 8100819) is available for bunk feeding or additional material control.
3.4.2 Changing length of cut
CHANGING STRIPPER PLATES
Adding stripper plates will produce a finer cut and removing plates will produce a coarser cut. (See Figure 3.7 and
section 3.1.5)
For a finer cut, one or two more stripper plates can be added. Space the added stripper plates 4” apart and drill five (5)
17/32” holes for each plate using the plate as a guide. Install the plate with five 1/2” x 1-1/2” bolts, flat washers, lock
washers, and nuts.
In applications such as land reclamation, where a very coarse cut is desired, the stripper plate may be removed.
Figure 3.6
deflector adjustments -
deflector release lever
and deflector latch
handle.
deflector release lever
deflector latch handle
deflector position indicator