25
has the same length and angle as illustrated.
Chain Bar
1. Reverse the bar occasionally to prevent partial wear.
2. The bar rail should always have parallel internal faces (see
diagram). Check for wear of the bar rail. Apply a ruler to the
bar and the outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is worn. Such
a bar needs to be corrected or replaced.
TROUBLE SHOOTING
CAUTION!
Always switch off the engine and pull the ignition cable before starting any inspection or
adjustment work. If, after making an adjustment or repair to the engine, you let it run for a
few minutes, remember that the exhaust and other parts will get hot. Do not touch parts that
emanate heat, as these may burn you.
The following table provides solutions to common problems encountered with the chainsaw.
