9
Chapter II: Basic Configuration and Setup
2-1 Build your network (Initial hardware setup)
Please follow these instructions to build the network connection between the Hi-Gain™
Wireless-300N Smart Dish Repeater and your computers and other network devices:
1.
Connect the power adapter to the Smart Dish Repeater
2.
Connect all ‘wired’ users to the HAW2DR via the Wired Local Area Network (LAN)
ports in grey. For wireless users, scan for the SSID of the Smart Dish Repeater
(Smart_Dish_Repeater) and connect. You must be within range of the Smart Dish
Repeater before connecting.
3.
Check to see the activity of the LEDs on the front panel. The PWR LED should be on.
The LAN LEDs should be on if the computer / network device connected to the
respective port of the Smart Dish Repeater is powered on and properly connected. If
PWR LED is not on, or any LED you expected is not on, please recheck the power
connection, or jump to
“5-2 Troubleshooting”
for possible reasons and solutions.
Summary of Contents for HAW2DR
