Hawk HA-FM11, Manual

Page: 28 / 40

time engines start failure. If failure at the fourth time, it would show
OFF
icon on screen. While remote start the engine in arm status, it need to disarm
the car before get into the car, and put the key from ACC to ON, but no need
to ignition again, do not forget to hold the foot brake before your drive the
car. After remote start the engine, if the user still not get into the car and the
time is up, engine would turn off.
(3) Pre-heat the engine before remote start engine (Available for diesel
vehicle only)
The function is available for diesel vehicle which need to preheat the engine.
It need to set up DIESEL vehicle mode from transmitter. For details please
check the Section 8 of <the instruction of the icon setting>. Before install the
system, please make sure if the engine need to preheat, and then connect the
preheat light response wire base on negative/positive trigger.
(4) Turbo charge engine protection (programable)
The function available for the vehicle with turbo charge engine. The function
can keep the engine run for 1 ~ 5 min after taking out the ignition key (can be
programmable). When the engine at idle running state, the temperature from
turbo charge engine would Low down, to prevent from engine temperature
returning after the engine turn off, and effectively reduce oil coking that maybe
damage the engine. When taking out the ignition key, the engine would keep
running for 1 to 5 min, at the moment, to hold the foot brake, the engine would
turn off. That mode fit for manual shift vehicle. For program, please see the
chapter 12 of the instruction of the icon.
(5) Under the low temperature to remote engine start
When met a low temperature condition, it can pre-set a temperature value to
remote the engine, when the temperature lower than the pre-set value, that
detected by the temperature sensor, the engine would start. The function can be
program from remote, for details please check the section 6 of
<Instruction of the icon setting >
Attention: 1. if the engine starts failure because of some mistake, such
as not meeting condition for engine start, the temperature sensor
broken, or failure engine. Start for 4 time, or etc. Remote engine start in
low temperature automatically cancel. 2. Reply on temperature sensor,
the time interval of continuously remote start engine is depending on
the frequency of the cooling engine.
HA-FM11 manualv3_p21-40_Layout 1 15/08/2016 19:06 Page 8