Haulotte HA 41 PX, Operating And Maintenance Instructions Manual

Page: 59 / 82

Operation and Maintenance
47
Caution !
Report the measured values in a copy of the table below:
If one of the values measured is higher than the maximum acceptable
value, contact Haulotte Services for repair of the affected jack(s)
before returning the machine to service..
5.3.3 - List of consumer items
• Hydraulic filter cartridge.
• Air filter element.
• Fuel pre-filter.
• Fuel filter.
• Engine oil filter.
• Fuses.
5.4 - LOAD TESTING
The tests below are to be performed after:
• a major strip down operation.
• an accident resulting from a critical component failure.
The following tests must be carried
out by a competent person under
controlled conditions with test
results being fully documented.
5.4.1 - Overload Test
The structural overload test is 125% of the rated safe working load. See
§1.12.3 of AS1418.10-1996 for details of the test.
• HA32PX : overload test is 287,5 kg
The machine is to show no signs of permanent deformation.
5.4.2 - Functional test
These tests are to demonstrate that:
• The machine can operate smoothly through all motions whilst carrying
the rated safe working load.
• All safety devices are working correctly.
• The maximum permitted operating speeds are not exceeded.
5.4.3 - Stability test
Stability test is performed in order to demonstrate that the machine is
stable in the least favorable position. The worst case overturning moment
applied represents the least favorable loads and forces combined.
Measu-
red va-
lues 1
Measu-
red va-
lues 2
Displacement = 2-1 Max ac-
ceptable
value in
mm
Corresponds to the positioning of
the jacks
X dX 13 Arm raised
B dB 6 Fly jib raised
C dC 6 Platform compensation receiver
D dD 6 Suspension platform
F dF 170 Télescopic arm and/or connector
piece and /or fly jib raised compen-
sation