Haulotte HA 41 PX, Operating And Maintenance Instructions Manual

Page: 54 / 82

Operation and Maintenance
42
5.3 - OPERATIONS
5.3.1 - Summary table
FREQUENCY OPERATIONS NUM-
BERS
Daily or before each
use • Check the levels of the:
- engine oil
- coolant
- hydraulic oil
- fuel
- electric batteries
• Check the cleanliness of the:
- fuel pre-filter
- engine air filter
- machine (specifically check the water-tightness of the connections
and flexible components), and take the opportunity to check the
state of the tyres, cables and all accessories and equipment.
- Check the status of the hydraulic oil filters; there is an indicator
to show this, change the cartridge if the visible indicator appears.
- Check the degree of usage of the articulated axles.
- Check the main safety items:
- When the machine is powered up, all of the indicator lights should
light momentarily
- Tilt: with the machine unfolded, tilt the support panel beyond an
angle of 4°, at which point the alarm will sound, and any lateral
movements or extension of the telescopic arms will be prohibited
- Speed limiter: only slow speeds are possible if the arm or fly jib
are raised, the telescopic arms extended or if the suspension plat-
form is beyond the horizontal
- Check and if required readjust the setting of the connection point
(see the procedure in chap. 4.4.1.3, page 32)
- After a complete deployment of the arm and fly jib of the machine,
the error indicator should remain unlit
1
2
3
4
5
6
7
Every 50 hrs • Engine: see manufacturer's notice
• Check the level of the reduction gear of the powered wheels (see
chap. 5.3.2.2, page 44)
• Check the level of the steering reduction gear (see chap. 5.3.2.2,
page 44)
• Grease the:
- steering axle, central pivot and clevis pin: 10 points
- steering crown wheel: the teeth (with a brush)
- pendular articulation axle: 2 points
- pendular articulation axle connecting piece: 4 points
- fly jib base axle: 1 point
• Clean the fuel pre-filter:
8
9
31
11
13
14
15
30
16
50 first hours • Change the hydraulic filter cartridges (see 250 hr frequency)
• Drain the reduction gears of the powered wheels (see 500 hr frequency)
• 4 points on the 4x4 model
• Check the tightness of the steering crown wheel screws (torque 21.5
mdaN)
• Check the tightness of the fly jib telescopic action chains.
17
18
19
35
100 first hours • Drain the steering gear (see 2000 hr frequency) 32
Every 250 h • Engine: see manufacturer's notice
• Grease the chafing portions of the telescopic arms
• Grease the steering crown wheel: 2 rolling points
• Check the state of the telescopic action friction pads
• Check the tightness of the wheel bolts (torque 57 mdaN)
• Changer the hydraulic filter cartridge
• Grease the chafing portions of the telescopic axles (with a spatula) 20
21
12
22
23
34