tach them to the truck’s battery termi-
nals, making sure to connect to the
correct polarity. (RED wire to
Po, BLACK wire to
Negative --)
(See Assy. diagram.)
Insert the Winch Remote Control
5.
(27A) into the Connector on the Sole-
noid Box Assembly (25A).
(See Assy. diagram.)
Check to make sure the Winch winds
6.
up the Steel Cable (15) when you
press the RED Button on the Remote
Control (27A).
(See Assy. diagram.)
Check to make sure the Winch
7.
unwinds the Steel Cable (15A) when
you press the BLACK Button on the
Remote Control (27A).
(See Assy. diagram.)
OPERATIng InSTRuCTIOnS
Read the EnTIRE IMPORTAnT
SAFETY InFORMATIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Loading Instructions:
Remove the Travel Lock Pin (50).
1.
(See Figure H.)
Check the Winch Remote Control
2.
(27A) by briefly pressing the BLACK
Button and then the RED Button.
The RED Button causes the Winch
to reel in. The BLACK Button causes
the Winch to reel out.
(See Assy. diagram.)
While unreeling the Winch with the
3.
BLACK Button, pull the Large Slide
Base (21) from the truck bed. The
Large Slide Base will hit an internal
stop when it is fully extended.
(See Assy. diagram.)
Install a Small Lock Pin (51) prior to
4.
loading the Slide Base (21).
(See Figure I.)
FIguRE I
SMALL
LOCK PIn
(51)
Remove the Small Lock Pin (51) to
5.
allow the Wheel Bracket Assembly
(39) to travel down the Large Slide
Base (21).
(See Figure j, next page.)
SKU 99900
For technical questions, please call 1-800-444-3353.
Page 9
FIguRE H
LARgE LOCK PIn
(50)