Hatteland JH 10T06 MMD, User Manual

Page: 81 / 84

81
IND100077-6
INB100005-1 (Rev 19)
Appendix
Notes
General Notes: (For all products)
- Other type approvals applies for the different products.
Please see
Testing & Approvals Overview
section in this manual for more information.
- Use of brightness and push buttons may inhibit visibility of information at night.
Note for ECDIS Systems:
For ECDIS systems the brightness knob indication mark should be aligned directly with the
indication mark located on the label. (See Physical Overview or Operation section elsewhere in
this manual)
VGA BIOS Firmware Verify: (On MMD and similar products only)
To verify your BIOS Firmware version, the version number is displayed in the UTILITIES menu in
the right top corner. If no version number shows, you may have a BIOS Firmware below V1.00
This manual currently applies for these BIOS Firmware Versions:
V0.xx / V1.00 / V1.10 / V1.2 / V1.2xx / V1.3xx / V1.5xx / V1.6xx / V2.0xx
V0.xx through V1.6xx (Introduced/used in early 2001 to 2006) - V2.0xx (Introduced late 2006)
As the available functions are nearly indentical between older products and V1.6xx, there should
be no critical need to update the BIOS Firmware (revision V0.xx and up to V1.6xx). In such case,
consult your local technician or sales/technical personnel at Hatteland Display if problems arise
during the installation, upon usage of the product or lack of support for your signal refresh rate etc.
For certain versions the entire graphical board must be changed by a qualified Hatteland
technician or a representative. A BIOS software upgrade is not possible.
VGA BIOS Firmware Versions: (On MMD and similar products only)
On products: V0.xx to V1.1xx = The advanced version of the OSD menu by startup default.
On products: V1.2xx to V1.5xx = The simplified version of the OSD menu by startup default.
On products: V1.6xx and up = The
memorized state
version of the OSD menu by startup default.
Advanced/Service Menu:
You will have a full set of functions available for your personal perference. Only for experienced
users.
Simplified/User Menu:
You will have a limited set of functions available for your personal perference. For the common
user.
Memorized State Menu: (Also referenced as “Normal/Toggle”)
The menu will either be advanced or simplified upon startup of display. If user changes from
simplified to advanced menu or visa versa, then this will be memorized in memory and it stays in
that mode until user changes it back again. This is only active on VGA BIOS Firmware versions
from V1.6xx and up.