26
User Controls
INB100005-1 (Rev 19)
IND100064-17
BRIGHTNESS AND CONTRAST: (No function in DVI mode)
Selecting this function will enable the user to adjust brightness and contrast
for the display.
(No Function in DVI)
BRIGHTNESS:
Increase/decrease brightness level, total: 100 steps
(No Function in DVI) CONTRAST:
Increase/decrease contrast level, total: 100 steps
COLOR TEMPERATURE
:
Selecting this function will enable the user to modify the warmness of the picture.
Higher temperature = “cooler” picture. Lower temperature = “warmer” picture.
User can select between
9500K, 8000K, 6500K,
and
5000K
color temperature measured in
Kelvin degrees. Press “+” to access the sub-menu, where the RGB values can be adjusted.
Use “+” and “-” buttons to adjust these values, and “MENU” to exit. (Saving is done automatically)
FREQUENCY AND PHASE: (Some functions not available in DVI mode)
Selecting this function will enable the user to modify the image horizontal size and
fine tune the image quality.
(No Function in DVI) FREQUENCY:
Increase/decrease the image horizontal size.
(No Function in DVI) PHASE:
Fine tune the data sampling position (adjust image quality.)
(No Function in DVI) SHARPNESS:
Increase/decrease video image sharpness level.
PICTURE TYPE
: Motion / Still (Adjustment for best image quality)
If graphics on screen move a lot, select “Motion”
If graphics on screen are mostly still, select “Still”
VIDEO ADJUSTMENT:
Selecting this function will enable the user to modify the color saturation of the
picture, tint and sharpness.
COLOR:
Increase/decrease video color level.
TINT:
Increase/decrease tint level.
SHARPNESS:
Increase/decrease video image sharpness level.
PICTURE TYPE
: Motion / Still / Normal (Adjustment for best image quality)
If graphics on screen move a lot, select “Motion”
If graphics on screen are mostly still, select “Still”
General motion - non flicker mode, select “Normal”
VIDEO TYPE
: Change to best match the source signal. (DVD / VCR)
VIDEO SYSTEM:
Selecting this function will enable the user to select video system and input signals.
AUTO
: Automatic detection of NTSC or PAL system. (Not applicable in SECAM)
NTSC / NTSC 4.43 : Manual select NTSC system.
PAL / PAL M
: Manual select PAL system.
SECAM
: Manual select SECAM system.
OSD Menu Functions
4
2
4
2
1
2
4
3
4
3
Summary of Contents for JH 10T06 MMD
