HARWI ORCA 1850, Manual

Page: 17 / 79

17
ADJUSTING THE MEASURE FOR VERTICAL CUTS
1 Lock the slide way at the zero point of
the measure scale.
2 Move saw unit upwards.
3 Place length stop at the left or at the
right side of the zero point.
4 Adjust measure and swing the clamp
forwards. Stop clamps automatically (Fig
15).
5 If the measure to be adjusted is bigger
than 1000 mm move the slide way one
position to the left.
EXAMPLE:
Width of cut has to be 23 cm.
Adjust measure at 23 cm.
Place the material against the aluminium
cap of the length stop.
Lock the slide way at the zero point of
the measure scale.
EXAMPLE:
Width of cut has to be 123 cm.
Adjust measure at 123 cm.
Place the material against the aluminium
cap of the length stop.
Lock the slide way at the zero point of
the measure scale
OR
Adjust measure at 23 cm.
Place the material against the aluminium
cap of the length stop.
Lock the slide way one position to the
left of the zero point (if the stop was
place at the right side of the zero point).
Fig. 15