HARWI ORCA 1850, Manual

Page: 19 / 79

19
VERTICAL CUTTING
LOCKING CONTROLLER VERTICAL CUTS
0 The machine is equipped with a locking
controller against vertical cutting of the
plastic strips. The vertical slide way has
to be locked in the notches and the saw-
unit has to be positioned for vertical
cutting. In case the locking of the vertical
slide way or the positioning of the saw
unit is not done properly, the motor will
not start.
Always cut from top to bottom.
1 Position the motor carriage at the top of
the slide way.
2 Adjust measure and position the material
against the aluminium cap of the length-
stop.
3 Take the handle of the depth
adjustment.
4 Switch on motor.
5 Push saw unit forward.
6 Pull the saw-blade steadily down through
the material (Figure 17).
Meanwhile turn the handle to the left.
7 When the plate is cut, pull the saw-blade
out of the material by means of the
handle.
8 Switch off motor.
9 Swing clamp of length stop upwards.
10 Remove material.
Fig. 17