HARVEY C-18VS, Instruction Manual

Page: 6 / 24

5
Electrical Requirements & Switch Operation
WARNING!
All electrical connections must be done by a qualified electrician. failure to comply may result in
serious injury! Adjustments or repairs-must be done with the machine disconnected from the
power source.failure to comply may result in serious injury!
POWER SUPPLY
Warning! This band saw came pre-wired for 230v
operation and must be connected to an appropriately
grounded 230v outlet as showen in fig. 1
GROUNDED
Warning! if outlet is not properly grounded, this band saw Fig. 1
can cause electrical shock.particularly when used in
damp locations. to avoid shock or fire, if the power
cord is worn or damaged in any way,have it replaced
immediately.not all outlets are properly grounded. if you
are not sure if your outlet is properly grounded, have it
checked by a qualified electrician.
Warning! To maintain proper grounding of your band saw.
do not remove or alter the grounding prong in any manner. Fig. 2
SAFETY SWITCH OPERATION
The operation box as shown in fig. 3 needs to be installed to side
of frame ,see assembly section in this manual for further instructions.
Do not turn the band saw on until all assembly and adjustment
instructions have been done.
As shown in figure 3:
Speed display (A) Stop button (B) Position switch(C)
Start button(D) Speed control knob(E)
To start the band saw, press the green start button (D) . and to
stop the band saw, press the red stop button (B).
Fig. 3
A
B
C
D
E