HARVEY C-18VS, Instruction Manual

Page: 9 / 24

8
Saw blade assembly
First, remove the bedplate protection
plate(B) and Loosen handle(C), and then
saw blade (A) Bedplate crack on the
bedplate center and across the flywheel,
up and down on the up and down
Saw card center, then turn the saw blade
Tight grip (D), tensioning saw blade,
again Installed protection plate (B), at last
Lock knob (C). As shown in figure 10.
Fig. 10
Switch of the door
Pictured above 10 H for the limit switch; K for the key, when the door is open, start button is
failure, must limit switch closing rear can normal boot; On the other hand, when the normal work,
open the door, the motor stop working immediately.
Warning: the normal work, directly open the door is not allowed, because the rotation
inertia, saw wheel is still turning, when open the door after the full stop. Keep the limit
switch keyhole clean, especially the door of the keyhole.
A
B
D
C
H
H
K
K