HARVEY C-18VS, Instruction Manual

Page: 11 / 24

10
ADJUSTING WORKING TABLE
First of all, loosen the handle (D) rotating
counter hand again(B), make the pointer to 0 °
then combination with Angle ruler to measure,
ensure straight on side and bedplate Angle is
90 °,if inconsistent, you may need to adjust,
indeed Pointer display scale is consistent with
the combined Angle ruler, then lock screw (C),
the most after the lock handle (D).
As shown in figure 13.
Fig. 13
ADJUSTING RIP FENCE
1. First turn on the Rip fence assembly(A)
close to the T slot(B) side;
2. Adjust the Rip fence assembly , make
the side parallel to T slot. as shown
in figure 14.
Fig. 14
ADJUSTING THE TABLE 0°--- POSITION STOP -20°
1. Loosen the workbench handle(C), rotate the
bedplate(A), make the Angle pointer to 0 °
then adjust the zero support (B), so that just
in 0 °to resist bedplate, then lock nut (E)
as shown in figure 15.
2. Loosen the workbench handle(C), rotate the
bedplate(A), make the Angle pointer to -20 °
then lock nut (D) as shown in figure 15.
Fig. 15
A
B
90°
A
B
C
D
B
A
A
D
C
E