HARVEST H1392, Assembly Manual

Page: 7 / 66

7
Receiving and Unpacking
1) Open all crates, boxes; pull out all parts, bags of parts, and hardware.
2) Now proceed to remove all shipping blocks and stops so that they are not left to cause damage to the auger or as
your laying them out
3) check to make sure you have the right amount of hardware, and that you have received all the parts and
hardware so that you will be able to find and assemble the auger, without missing or delay in final assembly,
Missing, Damaged or Replacement Parts
1)
With the highest of standards we attempt to ship every order with all Parts necessary to
assemble our products
, With that been said; We also understand that there are circumstances that or out of
our hands, to which parts may be misplaced, lost and/or damaged
2) If there is missing parts
Tel: 712.213.5100 or 888.218.5373
to report the missing parts and\or hardware
so that they can be shipped directly out to you.
Where to Start
1) At this point you will need to decide what you want to work first the carriage assembly or with the tubes, if
you want to start with the carriage assemblies turn to page 35.
2) If you want to start with the tubes then go to the next page.
3) You will want to remove all the flighting from the tubes and inspect both them for any shipping damage. Reinsert
the flighting making sure that there is a stub shaft and open tube ends facing each other.
4) You will start from one end and working your way to the other end of the auger one tube junction at a time.