HARVEST H1392, Assembly Manual

Page: 14 / 66

14
You’re ready to install the In-Feed Housing
Step 10
1) Start by sliding the in feed housing over the flighting that is protruding for auger tube one,
2) The in feed will have the tongue on one side and an opening the same size as the auger on the other,
3)
^ůŝĚĞŝƚďĂĐŬƚŝůůŝƚŝƐĂŐĂŝŶƐƚƚŚĞĂƵŐĞƌƚƵďĞĨůĂŶŐĞ͕ƚĂŬĞ;ϲͿЪ͟yϭЪ͟ĨůĂŶŐĞďŽůƚƐŝŶƐĞƌƚƚŚĞŵƐŽƚŚĂƚƚŚĞďŽ
lt
ŚĞĂĚƐĂƌĞŽŶƚŚĞƚƵďĞƐŝĚĞĂŶĚƚŚĞƚŚƌĞĂĚĂƌĞŽŶƚŚĞŝŶĨĞĞĚƐŝĚĞ͕ƚŚĞ;ϰͿďŽƚƚŽŵЪ͟yϭЪ͟ďŽůƚƐĂƌĞŝŶƐĞƌƚĞĚƐŽ
that the threads are on the tube side and the heads or on in feed side, use (10) ½” flange nuts tighten all bolts.
FIG 10- 1
Step 11
1)
dĂŬĞƚŚĞďĞĂƌŝŶŐǁŝƚŚƚŚĞϰďŽůƚƐƋƵĂƌĞŚŽƵƐŝŶŐ͕ϭЬ͟ŝŶƐŝĚĞďŽƌĞĂŶĚĞĐĐĞŶƚƌŝĐůŽĐŬŝŶŐĐŽůůĂƌ͕
FIG 11- 1
2) Slide it over the top shaft which is located and protruding outwards towards the top of the in feed assemble, use
;ϰͿЪ͟yϭЪ͟ĨůĂŶŐĞďŽůƚƐĂŶĚƉůĂĐĞƚŚĞЪ͟ĨůĂŶŐĞŶƵƚƐŽŶƚŚŽƵŐŚƚƚŚĞďŽƚƚŽŵŝŶƐƉĞĐƚŝŽŶŚŽůĞĨƌŽŵŝŶƐŝĚ
e of the
in feed housing, making sure that the grease fitting is pointing up,
3) Push on the locking collar against the bearing, turn the collar clockwise to lock, using a punch tap the lock collar
till tight. Tighten set screw on lock collar using Allen wrench.
Auger Tongue
Infeeder housing
First tube assemble
ϭЬ͟ďŽƌĞďĞĂƌŝŶŐ
block
Auger flighting
shaft
Grease fitting